Aube TH135 02 Thermostat User Manual

Home

href="
TH135-02  
Installation and User Guide  
Electronic Thermostat for Heating System  
1
.
2.  
Installation  
Thermostat Configuration  
o
Before installing the thermostat on the wall, it must be configured  
using the dip switches at the back.  
n
CAUTION: To avoid electric shocks, deactivate your heating system at the  
main electrical panel. Read the instructions carefully before disconnecting the  
wires.  
1.1  
Installing a New Thermostat  
For a new installation, select a position about 5 feet (1.5 m) above the floor,  
where there is good air circulation. The thermostat must be installed on an  
inside wall.  
Avoid places where there are:  
air draughts (the top of a staircase, an air outlet,...)  
dead air spots (e.g., behind a door)  
direct sunlight  
chimneys or hidden pipes  
1
.2  
Thermostat Installation  
Remove the mounting plate from the thermostat.  
2
.1  
.2  
15- or 20-minute Cycles  
The TH135 can operate on 15- or 20-minute  
n
o
Loosen the screw holding the mounting plate to the  
thermostat.  
cycles. While 15-minute cycles provide  
greater comfort, the heating system will be  
running more often.  
Lift the lower part of the plate to remove it from the  
thermostat.  
p
q
Loosen the screw holding the wire cover, and remove it.  
Secure the mounting plate to the wall and make the appropriate  
connection (refer to section 2).  
2
Temperature Control Modes  
You can choose between two temperature  
control modes:  
Proportional Adaptive Mode  
This mode analyses previous cycles in order to define the length of  
the upcoming cycle. This mode guarantees optimal regulation of 3  
cycles (switch #1 to 20 min.) or 4 cycles (switch #1 to 15 min.) per  
hour, regardless of the season.  
1
n
.3  
Wiring  
Refer to the diagram. Connect one wire to either therminal and the other  
Ideal for:  
wire to the other terminal.  
Radiant or convection electrical heating system  
Circulator control in a hot water system  
Conventional Mode with Anticipation  
Connection to a circulator  
This mode turns the system On or Off when the temperature reaches  
preset levels. This mode is compatible with all heating systems. It is  
recommended for a multi-zone system or when a thermostat directly  
controls a furnace equipped with a combustion gas purge cycle of  
more than 30 seconds.  
Relay  
Connection to a boiler  
Furnace  
o
Put the wire cover back on.  
NOTE: If you have a CT240 telephone controller, refer to section 5.1 for  
hook-up.  
TH135-02  
400-135-005-B  
11/12/06  
1/3  
href="
5
.
2
.3  
.4  
Pump Protection  
For hot water installations, it is recommended  
Telephone Controller  
The TH135 incorporates a telephone controller interface which  
allows you to switch from the or setting to the Vacation setting  
), and vice versa using a touchtone telephone. You can, for  
example, start the heating of your secondary residence from your  
office on Friday, or your house from the airport or from your car on  
your way back from vacation.  
r
to activate the pump at least one minute  
every 24 hours in order to avoid seizure.  
Place switch #3 down to activate this function.  
(
For all other installations, leave switch #3 in  
the Off position (otherwise your system will be  
activated 1 minute every 24 hours).  
5.1  
Connection to the CT240  
The TH135 is designed to connect directly to the CT240 telephone  
controller. This combination allows the activation and deactivation of  
the Vacation setting from the CT240 or telephone.  
2
Temperature in °C or °F  
The TH135 is factory-set to °C. If you wish to  
change the temperature display to °F, slide  
switch #4 upward. Please note that if you  
change from °C to °F or vice versa, you must  
reset the Comfort ( ), Economy ( ) and  
Connect the CT240’s terminals A and C to the TH135's terminals X  
and C respectively. You must respect the polarity.  
Vacation ( ) settings accordingly.  
For details on operating the telephone controller, refer to the CT240’s  
instruction manual.  
3
.
Battery Installation  
p
5
.2  
Operating the Telephone Interface  
You can activate the Vacation setting using the Vacation button of the  
Appears when the  
setpoint is displayed  
telephone controller ( ) or using a telephone from outside of the  
house.  
Temperature display  
Percentage  
of heating *  
Preset temperature icon  
n To activate the Vacation setting, press the Vacation button of the  
CT240 ( ). The Vacation setting will be displayed for 5 seconds  
*
The thermostat displays the percentage of heating required to maintain the desired tem-  
and the ( ) icon will flash on the screen. You no longer have  
access to the TH135 keypad if this function is activated by the  
telephone controller.  
perature. For example,  
is displayed when heating is activated at 40 percent.  
Display  
%
of heating  
1 to 24% 25 to 49% 50 to 74% 75 to 99%  
100%  
o To deactivate the function and return to the previous setting,  
press the Vacation button of the telephone controller again or  
use a phone. The red light will go off and the ( ) icon will  
disappear within 5 seconds.  
When you first install the batteries in the TH135, the unit runs a  
sequence of tests for approximately 5 seconds. After the tests, the  
screen should display the current temperature.  
It is normal for the displayed temperature to be higher than the room  
temperature if you are holding the TH135 in your hands. It will return  
to normal about one hour after installation on the wall.  
6
.
Connection to a Home Automation System  
s
Mount the thermostat on the wall plate and screw it in place.  
The Vacation setting can also be activated from a home automation  
system.  
4
.
Temperature Settings  
q
Preset Temperature  
Comfort temperature  
Economy temperature  
Vacation temperature  
Default Setting  
20 °C (68 °F)  
18 °C (64 °F)  
10 °C (50 °F)  
n To set the Comfort temperature, select the desired degree using  
the buttons and push the button until the icon is  
displayed (about 3 seconds).  
o To set the Economy temperature, select the desired degree  
using the buttons and push the button until the icon is  
7.  
Battery Replacement  
t
The TH135 will display an icon indicating that the  
batteries must be replaced. This icon will flash for 60  
days. After this period, the thermostat will shut down  
your heating unit.  
displayed about 3 seconds).  
p To set the Vacation temperature, select the desired degree using  
the  
buttons and push simultaneously the and buttons  
until the  
icon is displayed (about 3 seconds). This setting is  
After the battery replacement, you have to  
used by the telephone controller.  
reprogram the  
).  
,
and  
settings (refer to section  
4
Even if the thermostat indicates that the batteries are  
good, it is recommended to replace them once a  
year at the beginning of the heating season.  
TH135-02  
400-135-005-B  
11/12/06  
2/3  
href="
8
.
9.  
Technical Specifications  
Power supply: 2 LR6 alkaline batteries  
Warranty  
;
AUBE warrants this product, excluding battery, to be free from  
defects in the workmanship or materials, under normal use and ser-  
vice, for a period of three (3) years from the date of purchase by the  
consumer. If at any time during the warranty period the product is  
determined to be defective or malfunctions, AUBE shall repair or  
replace it (at AUBE's option).  
u
Max. resistive load: 5A @ 240 VAC  
Max. inductive load: 2A @ 240 VAC  
Auxiliary input (telephone interface): 12 VDC, +/- 10 %, 2.5 mA  
Control device: Electronic  
Automatic action: Type 1 B  
If the product is defective,  
Storage temperature: -20 °C to 50 °C (-4 °F to 122 °F)  
Operating temperature: 0 °C to 50 °C (32 °F to 122 °F)  
(
i) return it, with a bill of sale or other dated proof of purchase, to  
the place from which you purchased it, or  
(
95 % relative humidity without condensation)  
(ii) contact AUBE. AUBE will make the determination whether the  
product should be returned, or whether a replacement product  
can be sent to you.  
This warranty does not cover removal or reinstallation costs. This  
warranty shall not apply if it is shown by AUBE that the defect or mal-  
function was caused by damage which occurred while the product  
was in the possession of a consumer.  
Temperature setting range in heating: 5° C to 30 °C (40 °F to 85 °F)  
Temperature display scale: 0.1 degree  
Temperature reading accuracy: +/- 0.5 °C (+/- 0.9 °F)  
Software: Class A  
Insulation: class II  
Protection degree: IP 20  
AUBE's sole responsibility shall be to repair or replace the product  
within the terms stated above. AUBE SHALL NOT BE LIABLE FOR  
ANY LOSS OR DAMAGE OF ANY KIND, INCLUDING ANY INCI-  
DENTAL OR CONSEQUENTIAL DAMAGES RESULTING,  
DIRECTLY OR INDIRECTLY, FROM ANY BREACH OF ANY WAR-  
RANTY, EXPRESS OR IMPLIED, OR ANY OTHER FAILURE OF  
THIS PRODUCT. Some provinces, states or regions do not allow the  
exclusion or limitation of incidental or consequential damages, so this  
limitation may not apply to you.  
THIS WARRANTY IS THE ONLY EXPRESS WARRANTY AUBE  
MAKES ON THIS PRODUCT. THE DURATION OF ANY IMPLIED  
WARRANTIES, INCLUDING THE WARRANTIES OF MERCHANT-  
ABILITY AND FITNESS FOR A PARTICULAR PURPOSE, IS  
HEREBY LIMITED TO THE THREE-YEAR DURATION OF THIS  
WARRANTY. Some provinces, states or regions do not allow limita-  
tions on how long an implied warranty lasts, so the above limitation  
may not apply to you.  
This warranty gives you specific legal rights, and you may have other  
rights which vary from one province, state or region to another.  
1
0.  
Customer Assistance  
If you have any questions on the product installation or operation,  
contact us at:  
705 Montrichard Avenue  
Saint-Jean-sur-Richelieu, Quebec  
J2X 5K8  
Canada  
Tel.: (450) 358-4600  
Toll-free: 1-800-831-AUBE  
Fax: (450) 358-4650  
Service Centre  
1
9
0 rue Ampère  
5500 Gonesse  
France  
Tel: 33 (0) 1 34 07 99 00  
Fax: 33 (0) 1 34 07 99 19  
For more information on our products, go to  
www.aubetech.com  
TH135-02  
400-135-005-B  
11/12/06  
3/3  

Trane BMTK SVN01D EN Thermostat User Manual

Honeywell CM907 Thermostat User Manual

Honeywell L6007 Thermostat User Manual

Aube TH401 Thermostat User Manual

Honeywell T8000 Thermostat User Manual

Honeywell T8401C1031 Thermostat User Manual

Honeywell Y460A2003 Thermostat User Manual

Honeywell TH3210D Thermostat User Manual

Honeywell T8524 Thermostat User Manual

Honeywell TH110 DP P Thermostat User Manual